Autotronic Training System
Interactive Computerized Automotive System
The whole system has been modularized to provide electronic and automotive courses with step-by-step experiments on educational technology training.
All theoretical, experimental and practical learning procedures are supported by personal computer assisted supervision and dedicated software.
The KL-800 can simulate the operation of fuel injection system, ignition system, and the control of exhaust gas, etc. Experiments include the characteristics, and operation of various sensors and actuators, monitored by microprocessor on the main unit.
Experiment 1 Connections and of RPM Sensors
Experiment 2 Connections and Measurements of Air-Flow Sensor
Experiment 3 Throttle Position Sensor (TPS)
Experiment 4 Coolant Temperature Sensor (CTS)
Experiment 5 Oxygen Sensor
Experiment 6 Vehicle Speed Sensor
Experiment 7 3rd Gear Switch of Automatic Gearbox (3GR)
Experiment 8 Park/Neutral (P/N) Switch
Experiment 9 Air Condition (A/C) Switch
Experiment 10 Power Steering Pressure
Experiment 11 Injector Circuit
Experiment 12 Control Ignition System
Experiment 13 Cooling Fan Relay
Experiment 14 Fuel Pump Relay
Experiment 15 Circuit of A/C Compressor Relay
Experiment 16 Idle Air Control Valve (A/C)
Experiment 17 Torque Converter Clutch (TCC)
Experiment 18 Carbon Canister Purge Valve (CCPV)
Experiment 19 Exhaust Gas Recirculation Valve (EGRV)
Experiment 20 ECM Operators Simulator
1. 89S51 computer interface monitor control
2. Data of fuel injection, ignition and exhaust gas can be acquired and monitored by computer.
3. Can be assembled as the injection system
4. With trouble-shooting simulation function
5. Switch-off input / output function when trouble-shooting is made